Door Reverse - Signature SFM3501A+X Instructions D'utilisation

Using the dispenser
• Push in the lever of the water dispenser with your glass.
• Releasing the lever, stops further dispensing of water.
• Flow rate is dependent on how far the lever is pushed back:
Fully back = full flow
Gently back = trickle
• As the level of water in your cup/glass rises, gently reduce the amount
of pressure on the lever to avoid overflow.
Notes: Push the water dispenser lever with a rigid cup. If you are using a
plastic disposable cup, then push the lever with your fingers from behind
the cup.
Clean the water tank
• Remove the water tank by pulling out the fixed handle.
• Take off the cap I. Clean the tank with warm and clean water.
• Install the water tank and push back the fixed handle.
• To prevent possible leakage, ensure that any parts removed during cleaning
are refitted correctly in their original locations.
Notes: The water tank and dispenser components are not dishwasher-
proof.
Drip tray
• Water dripping from the dispenser while in use, accumulates in the
drip tray.
• Remove the drip board. Clean the board and tray with a clean and
dry cloth.
• Put the drip board back.

DOOR REVERSE

Users can change the direction of opening according to one's own
needs. The concrete operating sequence is as follows:
1. Unscrew the two screw(8) that hold the bottom hinge(5)(right
side) to the frame. Take away the bottom hinge(5);
2. Unscrew the four screws(1) that holding the top cover(10);
3. Unscrew the three screws(4) that inserted in right upper hinge(3);
4. Unscrew the screw nut of the right upper hinge bin(2). Refit the
upper right hinge bin(2) into the left upper hinge(11);
5. Lift the door off the right upper hinge(3) and place it on a flat
surface to prevent scratching it;
6. Unscrew the left front leg(9) and transfer it to the right side;
7. Set the door in place, making sure the door seat at the left upper
hinge bin(11);
8. Before placing the bottom hinge(5), remove the bolt-pin(6) and
reverse the direction of the bottom hinge(5). Then install the
bottom hinge(5) onto the left side of the lower frame with two
screws(8);
-26-