HIKOKI NV 100H Mode D'emploi page 13

6. Inspecting the muffl er
This Nailer has a built-in muffl er in the exhaust to reduce
noise and stirred-up dust during exhaust.
When the mesh of the muffl er is fi lled or the muffl er
is damaged, replace the muffl er with a new one. To
replace the muffl er, contact our Authorized Service
Center (Fig. 22).
7. Inspecting the magazine
Clean the magazine. Remove dust of wooden chips
which may have accumulated in the magazine.
8. Storing
○ When not in use for an extended period, apply a thin
coat of the lubricant to the steel parts to avoid rust.
○ Do not store the Nailer in a cold weather environment.
Keep the Nailer in a warm area.
○ When not in use, the Nailer should be stored in a warm
and dry place.
Keep out of reach of children.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
COMPRESSOR
CAUTION
When the maximum, operating pressure of the air
compressor exceeds 23 bar (320 psi), be sure to
provide a reducing valve between the air compressor
and nailer. Then, adjust the air pressure within the
operating range of 12 – 23 bar (170 – 320 psi). If the
air set is installed, lubrication is also possible, thus
providing additional convenience.
APPLICABLE LUBRICANTS
Type of lubricant
Recommended oil
Motor oil
Turbine oil
Name of lubricant
SHELL TONNA
SAE10W, SAE20W
ISO VG32 - 68
(#90 - #180)
Noise Information
Noise characteristic values in accordance with EN ISO
11148-13:2018
The typical A-weighted single-event sound power level
The typical A-weighted single-event emission sound
pressure level at work station
Uncertainty K: 2.5 dB (A)
These values are tool-related characteristic values and do
not represent the noise development at the point of use.
Noise development at the point of use will for example
depend on the working environment, the workpiece, the
workpiece support and the number of driving operations,
etc.
Depending on the conditions at the workplace and the form
of the workpiece, individual noise attenuation measures
may need to be carried out, such as placing workpieces on
sound-damping supports, preventing workpiece vibration
by means of clamping or covering, adjusting to the minimum
air pressure required for the operaion involved,etc.
In special cases it is necessary to wear hearing protection
equipment.
Vibration Information
The typical vibration characteristic value in accordance
with EN ISO 11148-13:2018, 2000: 5.3 m/s
Uncertainty K = 1.5 m/s
2
This values is a tool-related characteristic value and does
not represent the infl uence to the hand-arm-system when
using the tool. An infl uence to the hand-arm-system when
using the tool will for example depend on the gripping
force, the contact pressure force, the working direction, the
adjustment of energy supply, the workpiece, the workpiece
support.
English
L
,1s,d = 99.5 dB
WA
L
,1s,d = 91.6 dB
pA
2
13