Using The Cooktop; Select Temperature; Cooktop Safety Switch; Activating The Timer Function (Hc 1651S) - Asko HC1651s Mode D'emploi

USING THE COOKTOP

1
Place the saucepan
or frying pan on the
appropriate heating zone.
See the "Advice and Tips" chapter before
using the cooktop.
2
Press On/off
Then select the heating zone by pressing
one of the four buttons
3

Select temperature

Press
heat setting is displayed (1-9).
4
Select double zone (if
necessary)
Pressing either of the two buttons
for that heating zone (only available on
HC1651).
5
Turn off heating zones
Alt. 1. Press the
displayed. The heating zone turns off
after 5 seconds.
Alt. 2. Press the
at the same time and the heating zone
turns off after 1-3 seconds.
Then turn off the cooktop with the on/off
- Tangenter för val av stor zon
button and activate the child lock if you
wish.
The residual heat indicator
until the heat in the zone drops to
about 50°C.
NB:
Even if the residual heat indicators are
switched off, a heating zone may still be
hot due to heat from a hot pan.
8
.
.
or until the desired
activates the double zone
button until "0" is
- Tangenter för val av kokzon
- Tangenter för tidsinställning
and buttons
glows
- Visning av kokzonsstatus
- Ökningstangent (+)

Cooktop safety switch

If the control panel is covered for more than 20
seconds or if the temperature of the electronics
exceeds 60°C, the safety switch is triggered and
automatically turns off all cooktop functions until
the cause is rectified.
Activating the timer function (HC
1651s)
If you want one or more heating zones to turn
off after a certain time, you can use the cooktop's
timer function.
Do as follows:
1. Press the selection button of an activated and
set heating zone once or twice to activate its
timer function.
2. A flashing "00" indicates that the timer function
has been activated.
3. Set the desired time using the
buttons. The time set in the example is 12
minutes. The time can be set between 1 and 99
minutes.
4. Repeat the steps above if you want to set up
automatic stop times for several zones.
5. When the set time is reached, the zone is turned
off and a repeating alarm signal is heard. This
- Indikeringslampa för låsfunktion
must be turned off using the selection button
for the heating zone.

Lock function

- Låstangent
The cooktop is fitted with a lock function that is
activated at the factory. Deactivate it as instructed
under "Unlock" below.
You can lock the cooktop whether or not it is in
use. If you want to lock the cooktop when it is not
- Av / På tangent
in use, you must first turn off all functions and
then use the lock button to lock it.
Lock:
Press the lock button
until the indicator lamp lights and an audible
- Reduceringstangent (-)
signal is heard.
Unlock:
Press the lock button
until the indicator lamp goes out and an audible
signal is heard.
and
for at least 1-3 seconds
for at least 1-3 seconds