Össur ELATION Notice D'utilisation page 5

ATTENTION!
Use a sharp hex key. Special care needs to be taken when untightening/
tightening bolts for sizes 26-28 as the hex slot is shallow. If the hex slot is
worn out replace with a new bolt (Figure 5).
• Remove mounting bolts with hex key.
• Compress the heel bumper in order to expose the forefoot
bumper (a).
• Remove bumper.
• Position foot in maximum dorsiflexion to expose and remove heel
bumper (b).
• Replace with desired bumper ensuring the bumper is fully seated.
• Reassemble in reverse order.
• Apply Loctite 243 to mounting bolts, reassemble ankle to foot and
torque M6 bolts to 15Nm on sizes 22-25 and M8 bolts to 21Nm on
sizes 26-28.
Weight
50 kg - less
(110 lbs - less)
51 kg - 65 kg
(111 lbs - 143 lbs)
65 kg - 80 kg
(143 lbs - 175 lbs)
80 kg - 100 kg
(175 lbs - 220 lbs)
NOTE : A Dual Density Shin Fairing FCX0002 is available. It allows the
range of motion in the ankle section to be maximized without
compromising the integrity of the foam where it is attached to the foot
cover. The soft section also facilitates access to the push button on
Elation.
LIABILITY
The manufacturer recommends using the device only under the specified
conditions and for the intended purposes. The device must be
maintained according to the instructions for use. The manufacturer is
not liable for damage caused by component combinations that were not
authorized by the manufacturer.
CE CONFORMITY
This device meets the requirements of the 93/42/EEC guidelines for
medical devices. This device has been classified as a class I device
according to the classification criteria outlined in appendix IX of the
guideline.
COMPLIANCE
This component has been tested
according to ISO 10328 standard to two
million load cycles. Depending on the
amputee's activity this corresponds to a
duration of use of two to three years. We
recommend carrying out regular yearly safety checks.
Heel Bumper Selection Guide
Durometer
Soft
Medium
Firm
Extra Firm
Heel
Green
Black
Red
Orange
ISO - P -
*) Body mass limit not to be exceed!
For speci c conditions and limitations of use see
manufacturer's written instructions on intended use!
kg *)
5