FS S3900 MANAGED L2 GIGABIT SWITCHS Série Guide De Démarrage Rapide page 14

Con guring the Switch Using the Console Port
Step 1: Connect a computer to the switch's console port using the supplied console cable.
Step 2: Start the terminal simulation software such as HyperTerminal on the computer.
Step 3: Set the parameters of the HyperTerminal: 115200 bits per second, 8 data bits, no parity,
1 stop bit and no ow control.
Quick Connect
Protocol:
The port may be manually entered or selected from the list.
Port:
Baud rate:
Data bits:
Parity:
Stop bits:
Name of pipe:
Show quick connect on startup
Troubleshooting
1/10G Port is not Working
In the case of compatible cables and transceivers, the port cannot be up, please try to modify the
port mode to adapt or force the port speed to 1G/10G.
Connecting the Switch Remotely Unsuccessfully
1. Test network connectivity through ping.
2. If the network is reachable, try restarting the switch.
3. Check if the corresponding service is enabled.
Serial
COM3
115200
Flow Control
DTR/DSR
8
RTS/CTS
None
XON/XOFF
1
Save session
Open in a tab
Connect Cancel
x
13