Installation Notes; Instructions For Installation - Cata ME 406 TC Instructions

Oven accessories (Fig. 4)
The oven can be provided with lateral guides fitted to the oven
wall. Insert the grid and oven sheet provided on the lateral
guides. To remove the guides proceed as follows for the two
types:
To remove the lateral guides press downwards at point A.

INSTRUCTIONS FOR INSTALLATION

This appliance must be installed by a competent person, in ac-
cordance with the current version of the UK Safety Rules and
Regulations or their European equivalent:
Urban development regulations (published by the Department
of Environment).
Urban development laws (published by the Scottish Executive
Development Department).
IEE wiring regulations.
Electricity in labour regulations.
PRIOR START-UP OF THE APPLIANCE
When it is unpacked, check that the following parts are with
the oven:
• Instructions and Installation Manual
• oven grid
• 1 tray
• Screws and stoppers for fitting the appliance in the housing
FITTING THE APPLIANCE (see Fig. 5)
These appliances are classified as Class I.
The earth is obligatory as provided for by law. The manufactu-
rer declines all liability in the event that the accident preven-
tion rules have not been followed.
IMPORTANT
The adjacent piece or furniture or cupboard and all the mate-
rials used in the installation must resist a minimum temperatu-
re increase of 85 ºC above the ambient temperature during use
of the appliance.
Certain types of vinyl or laminated kitchen furniture are parti-
cularly susceptible to damage due to decolouration at tempe-
ratures below those indicated.
If the appliance is installed without paying attention to this
temperature limit or if it is placed less than 4 mm from the adja-
cent cupboards, liability will belong to the owner.

INSTALLATION NOTES

1. The oven has to be installed in a standard gap of 600mm, as
indicated in Fig. 5, whether under a hob or in a column.
2. On inserting the oven in a column, it is essential in order to
ensure there is enough ventilation, to remove the rear panel
of the furniture and have an opening of at least 85-90mm as
indicated in Fig. 5.
3. Check that the oven has been fixed securely in the housing.
Fixing the oven into the cupboard is done using 4 screws "A"
Fig.5. One in each corner of the oven door frame.
Fig. 5: Installation distanced for simple electric ovens of 60 cms
wide (the shape of the upper casing may vary) and attachment
to the cupboard.
450
560
85
20
456h
448
595
531
A. The support runner must be removed
B. Spacing of 75-90 mm between the wall and the rear part of
the support shelf and the base of the cupboard
C. Base
D. False box front to be assembled
450h
560