Battery Status Indicator; Charging The Battery; Safety Instructions - brennenstuhl professionalLINE 4000 M Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
023620 ORUM.qxp_023620 BA_ORUM 08.07.20 14:18 Seite 11

BATTERY STATUS INDICATOR

Indicates the current battery charge, showing how much energy is still available.
The battery status indicator (C) appears automatically when the floodlight is switched on.
While the battery is charging, the status indicator (C) shows the battery's charge level.
If all 4 LEDs are lit, the battery is fully charged.
If the battery is almost empty, the floodlight flashes 5 times and the battery status indicator (C) flashes
continuously. Afterwards, the floodlight will remain on for approx. 10 minutes before the light is switched off by
the deep discharge protection function. This ensures sufficient time to complete work.

CHARGING THE BATTERY

1. To ensure optimum function, we recommend fully discharging the battery on the first use and fully charging
it afterwards.
2. The charging port (B) is located under the cover cap on the side of the floodlight.
3. The charging status of the battery is indicated by the battery status indicator (see description above).
4. If the device is not used for longer periods of time, charge the battery at regular intervals of approx.
3 months to ensure a long service life.
5. After charging, always close the charging port with the cover cap.
CABLE WRAP
The cable can be wrapped around a groove in the light for transport and storage.
OPTIONAL STAND ACCESSORIES
• 1170310 stand ST 300
• 1170610020 stand ST 250
• 9171991100 stand TS 300
• 1172640059 cross-member CB 70

SAFETY INSTRUCTIONS

1. Check the light and mains cable for damage before every use. Never use the light if you find any damage.
Warning! A damaged light or mains cable can cause fatal electric shock!
2. If the light's mains cable is damaged, it must be replaced by a qualified technician to avoid hazards.
3. The light must be properly grounded.
4. The light must not be used without all sealing rings properly installed!
5. LED lights are extremely bright. Please never look directly into the light.
6. A destroyed protective cover must be replaced with an original Brennenstuhl protective cover before the
light can be used again.
www.professionalline.com
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Professionalline 4000 mhProfessionalline 8000 mProfessionalline 8001 m

Table des Matières