brennenstuhl professionalLINE 4000 M Mode D'emploi page 10

023620 ORUM.qxp_023620 BA_ORUM 08.07.20 14:18 Seite 10
Bolted on hanging light
OPERATION OF THE HYBRID MAINS FLOODLIGHT WITH BATTERY (4000 MH)
Use the switch (A) on the back to switch the floodlight on.
Press the switch multiple times to set the brightness to 100%, then 50%, then 25% and then "off".
The lower the brightness selected, the longer the floodlight will burn.
If the switch is left in any of its "on" positions for longer than 5 seconds, then pressing it once again will always
turn it off.
If the plug-in power supply is connected and plugged in while the floodlight is switched on, the floodlight will
flash 3 times and then automatically switch into mains operation with 100% light.
OPERATING THE HYBRID FLOODLIGHT WITH MAINS POWER
The hybrid floodlight connects to the mains power from the PSU plug (E) via the charging cable (D) to the
charging port (B).
A
By pushing the On switch, the floodlight produces light.
In the event of a power failure or if the mains plug is unplugged, the floodlight will flash 3 times and then
automatically switch into battery operation with 100% light.
If the hybrid floodlight is connected to the mains, the battery is charged. The charging display flashes.
It can shine light while being charged.
The battery charges fastest when the floodlight is switched to "off".
10 www.brennenstuhl.com
Hanging on a hook
E D C B
(A) Switch
(B) Charging port
(C) Battery, status and charge indicator
(D) Charging cable
(E) Power supply unit