13. MAINtENANCE
13.1. CONTROLS
It is your responsibility to take charge of maintaining integrity and efficiency of the CARRYTANK
cular periodically check:
– Periodically inspect the state of wear of the surfaces of the housing, with particular regard to those of the bottom, exposed to wear by
friction with lifting systems.
– the perfect sealing of the tank, paying the utmost attention to possible loss or leakage of the fluid at the nozzle, faucet, suction pipes and
discharge valves.
– the good condition of the inscriptions on the wrapping identifying the material (eg. "UN1202") and its harmfulness and, if damaged,
replace them with new ones of the same type and in the exact same position.
13.2. CLEANING
the CArrytANk
and its emptying device should be kept clean both by external agents (dirt, dust, etc.), and any accidental spills of
®
dangerous materials on the occasion of fills, flushes, loss.
For cleaning use non-corrosive products for metal parts and for electrical cables and plastics in general, preferring neutral or slightly
alkaline de greasing products. Steam systems can be used (puli-vapour steamer), provided that the jet is not directed against parts of
the electrical system or against the plates and/or adhesive plates applied on the body of the CArrytANk
emptying device.
13.3. TAMPERING
In addition to the provisions in § 13.4, for no reason you are allowed to change the tank as regards the characteristics of the electric emp-
tying device; in particular:
it is strictly forbidden to replace equipment with other components different from the original ones, without the ma-
nufacturer's warranty as regards pressure resistance.
13.4. SPARE PARTS
Any modification or replacement of parts of the housing, as a result of damage, accident or tampering, is allowed only at EMILIANA SEr-
BATOI Srl establishments or in centres authorised by it as the operation is configured as "reconditioning".
the use of non-original spare parts voids the manufacturer's warranty, if in course.
MAN_CArrytANk_rev.0 del 05/2017
®
35
and its devices and equipment, in parti-
and on the metal frame of the
®
EN