Risk of sustaining injury due to fire
There is risk of fire which may cause injury should the
device be connected to a supply line whose cross-section
is insufficient and/or is not adequately protected by a
fuse.
• Use an adequate fuse and a supply line with a sufficient
cross-section for the device.
Material damage due to insufficient cross-section
and/or inadequate fuse
There is a risk of overloading the device and subsequently
causing damage to the device should it be connected to a
supply line whose cross-section is insufficient and/or is not
adequately protected by a fuse.
• Use an adequate fuse and a supply line with a sufficient
cross-section for the device.
• Comply with the specifications given on the rating plate
and in the "Connected loads" chapter.
Ö
Please refer to the "Technical Data" chapter
Depending on the device version, the data on the
device can differ from the technical data as regards
content or be unavailable. If you have any questions
or need details, please contact your specialist dealer,
if necessary, or MENNEKES.
5.1 Unpacking the device
• Do not use sharp or pointed objects for opening the
package to avoid damage to the device.
• Open the packaging and take out the device.
• Store the packaging or dispose of it in accordance with
applicable regulations.
5.2 Checking the device for damage sus-
tained during transportation
• After unpacking, check the device for transport damage.
• If you determine that there is transport damage, contact
your dealer.
• Do not use a device that shows signs of damage.
8
Warning
Attention
5.3 Returning the device
If you want to return the device, use the original packaging
or a suitable, safe transport container.
5.4 Installing the device
The device is intended as suspended, stationary power dis-
tributor which also determines the position of use.
With a deviating position of use, the protection class requi-
rements can no longer be met, which is to be taken into
consideration in particular when using the device in an
outdoor area. Devices complying with protection class IP44
are protected against splash water but are not suitable for
continuous overhead sprinkling.
For devices installed in an outdoor area, corresponding
protective measures are to be provided, if necessary.
For a safe operation the device should be installed in a
height where it can be reached without additional auxiliary
equipment.
Specifications on the possible cross-sections of the supply
line can be found in the "Technical data" chapter.
• Please observe the country-specific regulations for the
erection and installation of electrotechnical facilities.
• Please observe the country-specific work protection
regulations.
Risk of loss of life from electric shock!
There is a risk of sustaining major injury or death when
working on or with live components.
• De-energise the supply line to the device prior to
commencing installation tasks.
• Secure the de-energised supply voltage connection point
against inadvertent reactivation by other persons.
• Check that the supply line is de-energised prior to
commencing installation tasks.
Danger