Device Dimensions; Conductor Cross-Section Of The Supply Line; Ambient Conditions - Mennekes DELTA-BOX 92898 Notice D'installation Et De Montage

13.2 Device dimensions

The device dimensions and other product information is
provided in the current MENNEKES product catalogue or on
the Internet under www.MENNEKES.de.

13.2.1 Conductor cross-section of the supply line

Depending on the device version, different conductor cross-
sections can be used for the supply line.
• Please observe the data in the following table.
• Further product information can be found in the current
MENNEKES product catalogue or online under www.
MENNEKES.de.
Device Number supply
line
AirKRAFT 1
®
3KRAFT 1
®
DELTA-BOX 1

13.3 Ambient conditions

For safe and trouble-free operation of the device, ensure
that the following ambient conditions are met.
Danger of injury due to unsuitable ambient condi-
tions
Unsuitable ambient conditions can damage the device,
which increases the risk of electric shock.
• Only operate the device under suitable ambient
conditions.
Material damage due to unfavourable ambient con-
ditions
Consideration should be given to local ambient conditions
when setting up the device. Failure to do so may cause
damage to the device (e.g. decreasing load capacity of
the device).
• Give due consideration to ambient conditions when
setting up the device and to ensure safe operation of
the device.
• Only operate the device if the grid data agrees with the
grid data on the rating plate.
20
Conductor cross-section
up to 5 x 6 mm
2
up to 5 x 10 mm
up to 3 x 6 mm
2
up to 5 x 10 mm
up to 3 x 10 mm
up to 5 x 10 mm
Warning
Attention
• Only use the device outdoors if the device or the supplying
socket is fused via a suitable residual current device.
• Prevent water from penetrating into the device, water
ingress increases the risk of electric shock.
• Do not enclose the device in an additional housing or
install it in the recess of a building before obtaining
approval from MENNEKES.
• To prevent overload and thus to prevent device damage,
do not cover the device.
• Do not use the device in explosive areas in which
combustible fluids, gases or dusts are present - danger of
explosion and fire!
• Only use copper supply lines.
Devices with plastic enclosure may suffer visual and quali-
tative impairment due to contact with chemical substances,
2
oil, lyes, grease or solvents, and due to thermal impacts.
For these ranges of application, we recommend using
2
AMELAN , a plastic with a high resistance against chemicals
®
and other aggressive substances.
2
2
• Only use devices which are intended for the respective
ambient conditions and which have the required material
characteristics.
• Where necessary, consult your specialist dealer or
MENNEKES.
Permissible ambient temperatures for operation (stan-
dard information)
Indoor and Outdoor Installation
Min.
- 25 °C
13.3 / 1
• Please also observe the device-specific data in the chapter
"Appendix".
Max. Mean Value for 24-hour Period
+ 40 °C not exceeding + 35 °C