Taking Out Of Service And Dismantling; Taking The Device Out Of Service; Disconnecting The Device From Voltage; Opening The Device - Mennekes DELTA-BOX 92898 Notice D'installation Et De Montage

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Tasks to be executed by a qualified electrician
Risk of loss of life from electric shock!
Danger of severe or fatal injury when touching energised
components.
• Only execute tasks on the device after you have
disconnected it from the power supply.
• Check the device for damage.
• Properly rectify any device damage.
• For repairs only use original spare parts from MENNEKES.
• After the repair check the device for proper function.
• If re-commissioning the device is not likely due to damage,
and with regard to further safe use, the device must no
longer be placed in service.
10. Taking out of Service
and Dismantling
The activities described in this chapter may only
be carried out by a qualified electrician!
Risk of loss of life from electric shock!
A risk of sustaining major injury or death is associated
with the improper handling of electrotechnical devices
and equipment.
The tasks described below may only be carried out by a
qualified electrician.
• Only carry out the tasks described below, if you are
a qualified electrician or possess the appropriate
knowledge and skills.
Danger
Danger

10.1 Taking the device out of service

10.1.1 Disconnecting the device from voltage

Risk of loss of life from electric shock!
There is a risk of sustaining major injury or death when
working on or with live components.
• Disconnect the supply line of the device from voltage
prior to commencing dismantling tasks.
• Secure the de-energised supply voltage connection point
against inadvertent reactivation by other persons.
• Check that the supply line is de-energised prior to
commencing dismantling tasks.

10.1.2 Opening the device

• Open the device
Ö
Please refer to the "Installation and start-up" chapter

10.1.3 Disconnecting and removing the supply line

Removing the supply line (example: AirKRAFT®)
• Disconnect the wires from the terminals (1).
• If necessary, loosen the clamp of the strain relief.
• Loosen the cable gland and pull the supply line out of the
enclosure.

10.2 Dismantling the device

• Remove the device from the ceiling fastening and / or
hanging.
Danger
1
EN
EN
EN
EN
NL
NL
FR
FR
IT
IT
17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

3kraft 94355si3kraft 94358geAirkraft 94566ge3kraft 94359roAirkraft 94555siAirkraft 94554si ... Afficher tout

Table des Matières