Selecting The Waveband/Memory Bank; Tuning Into A Station; Setting The Sensitivity Of Station Seek Tuning - Bosch CRD 47 MP3 Mode D'emploi Et De Montage

Radio mode
Selecting the waveband/memory
bank
This device can be used to receive programs of
the frequency bands FM, MW and LW (for the
tuner region EUROPE) or FM and AM (for the
tuner region NAFTA). There are three memory
banks available for the FM waveband (FM1,
FM2 and FMT) and one for each of the MW and
LW or AM wavebands.
Five stations can be stored in each memory
bank.
To switch between the memory banks and
wavebands,
press the BND•TS button 3.
Ñ
With the tuner setting EUROPE, you switch
between FM I, FM II, FM TS, MW and LW. With
the tuner setting NAFTA, you switch between
FM I, FM II, FM TS and AM.

Tuning into a station

There are various ways of tuning into a station.
Automatic station seek tuning
Ñ
Press the or
The radio tunes into the next receivable
station.
Note:
If the priority for traffi c information is
active (the display shows the TA
symbol), the next traffi c information
station is set.
Tuning into stations manually
You can also tune into stations manually.
To change the set frequency in small incre-
ments,
Robert Bosch Car Multimedia GmbH
button 6.
Ñ
briefl y press the
Note:
To tune into stations manually via the
buttons and
selected in the menu. For further
details, read the following section
"Selecting between manual and
automatic station tuning".
Selecting between manual and
automatic station tuning
Press the MENU button 7.
Ñ
Ñ
Press the or
until "AUTO" or "MANUAL" appears on the
display.
To select between MANUAL and automatic
(AUTO) station tuning,
button 6.
Ñ
press the or
To exit the menu,
Ñ press the MENU button 7.
Setting the sensitivity of station
seek tuning
You can select whether only strong stations
("LOCAL" setting) or also weak stations
("DISTANCE" setting) can be tuned into.
Ñ Press the MENU button 7.
Ñ
Press the or
until the display shows "MORE" and wait
until "CODE" appears.
Press the buttons BND•TS 3 and TA 5
Ñ
at the same time.
The current setting appears on the display. To
select the sensitivity,
button 6.
Ñ
press the or
7 620 210 011 | 10.2009
en | 33
button 6.
or
6 must be
button 6 repeatedly
button 6 repeatedly