Maintenance Of The Device; Changing The Soldering Tip; Statement Of Conformity - Parkside PLP 160 Mode D'emploi Et Instructions De Securite

• Direct the soldering tip towards the soldering point.
• Actuate the push-button switch . The operation indicator lights up
• In order to heat up the soldering tip, keep the switch pressed down for max 12 sec. before starting the soldering work until the necessary
soldering heat has been reached - then let go of the push-button switch.
Never operate the soldering gun for continuous peroids! The duration of the power supply controls the soldering heat (longer power
!
supply = higher soldering heat). During the soldering process, never keep the push-button switch pressed down for too long. Determine the
necessary duration of the power supply in practice by checking the soldering heat. Press the ON/OFF switch
12 seconds - then do not operate the gun for at least 48 seconds. As soon as you let go of the push-button switch, the soldering
heat is reduced automatically. If the switch is actuated again, the heat increases rapidly. Constant soldering heat guarantees an optimum
soldering quality, melting of the soldering tip due to excessive temperatures is avoided and the service life of the device is extended.
Prior to use, draw the soldering tip through the soldering paste which is also supplied.
Because the operating temperature is reached quickly, the device functions in a very energy-saving manner. The special shape of the
soldering-gun tip makes partial heating possible. Thus, the device is particularly operator-friendly and accelerates the heating process
in the case of tin soldering.

MAINTENANCE OF THE DEVICE

The tip and the housing of the soldering gun are connected via a contact piece. The soldering tip can therefore be repaired and replaced
conveniently. Because the tip melts and wears after lengthy use, it is necessary to replace it at regular intervals.

CHANGING THE SOLDERING TIP

Unscrew and remove the two fixing screws connecting the tip and the housing. Replace the old tip with a new one and re-insert and tighten
the screws. The device is then ready for operation once again.
REPLACEMENT OF THE LAMP
If the operation indicator is defective, return the soldering gun to the manufacturer or to the customer service. Power supply of the lamp: 6 V / 3 W.

STATEMENT OF CONFORMITY

We, Kompernaß Handelsgesellschaft mbH, Burgstr. 21, D-44867 Bochum, Germany, hereby declare that this product conforms
with the following EC regulations:
EC low voltage regulations/
Electromagnetic compatibility:
Applicable harmonised standards:
Brand name:
Type:
Description of the machinery:
Bochum, 31.07.2001
Hans Kompernaß - Managing Director -
(73/23/EEC), (93/68 EEC)
EN 60335-1:1994+A11+A1+A12
EN 60335-2-45:1996
PARKSIDE
PLP 160
SOLDERING GUN
7
for a maximum of