Operation; Pump Operation; Care Instructions; Maintenance - Steinbach Active Balls 50 Notice Originale

Operation

A damaged device or damaged accessories may cause injuries.
- Check the device and the accessories (see section "Testing").

Pump operation

Information on how the timer function works can be found in the "How the timer
works" section
Starting the pump operation
1. Connect the pump's power plug to the power supply.
The running time display is lit. If a battery is inserted, the last selected running time is
displayed.
2. Press the timer button
lit.
3. Press the ON/OFF button
The pump will now run nonstop for the selected running time. The timer function
activates the pump again at the same time on the following day.
The pump is running. Listen to the pump to check for any unusual noises. If there is air in
the system, bleed it again.
Stopping the pump operation
To stop the pump operation, press the ON/OFF button
deactivated only by disconnecting the pump from the power supply.

Care instructions

The filter system cannot filter out algae, bacteria and other microorganisms.
- Use special water care substances to prevent and remove these to ensure
hygienically clean water.
- Consult an expert and observe the dosage.

Maintenance

Exchanging the filter medium

The Steinbach filter balls should be exchanged every 2 to 3 years, depending
on the operating period and the amount of dirt on the device.
50
CAUTION!
Risk of injury!
several times until the LED of the desired running time is
29
to switch on the pump
30
.
10
. The timer function can be
30