Filtering Time; Before First Use; Check The Following Before Start-Up; Preparing The Pump - Steinbach Classic 310 Notice Originale

WASTE
- The pool can only be drained up to the minimum water level at the height of the suction
line. Make sure to switch the pump off once this level is reached to prevent the pump
from running dry.
Use this mode to clean the pool in the case of heavy soiling.
The water is guided past the filter and discharged directly via the backwash line.
WINTER
- Never switch on the pump in this mode!
Use this mode to store the filter system in the winter.
The valve lever is in an intermediate position which relieves the inner valve components.

Filtering time

The pool's water content should be circulated at least twice in a 24 h period. In case of heavier
frequency, the pool water should be circulated 3 to 5 times per day.

Before First Use

Risk of death when operating the water treatment system during bathing.
Hair or clothing might get sucked into the suction openings of the pool and in extreme cases
trap persons under water and prevent them from surfacing again.
- Never operate water treatment system devices while persons are in the pool.
- Prevent any access to the pool for as long as water treatment system devices are in use.
Clarifying agents in the pool water can lead to clumping of the Active Balls and severely
impair their cleaning effect.
- Do not use any clarifying agents for water treatment when using Active Balls as filter
medium.

Check the following before start-up

- The device is out of the pool and the power cable is disconnected from the mains

Preparing the pump

At the time of delivery, the pump is only partially assembled.
Only hand-tighten all screw connections. Excessive tightening of the screw connections
damages gaskets and plastic components. Do not use any tools.
You can use Teflon tape to seal screw connections with minor leakage.
NOTICE!
NOTICE!
WARNING!
NOTICE!
33