Technical Specifications - Stiga B 1.0 EJ Manuel D'utilisation

28
EN

10. TECHNICAL SPECIFICATIONS

Maximum noise and vibration levels [1]
Operator ear noise pressure level
with line cutter head
Measurement uncertainty
with 3-point blade
Measurement uncertainty
Measured acoustic output level
with line cutter head
Measurement uncertainty
with 3-point blade
Measurement uncertainty
Vibrations transmitted to the hand on the front handgrip
with line cutter head
Measurement uncertainty
with 3-point blade
Measurement uncertainty
Vibrations transmitted to the hand on the rear handgrip
with line cutter head
Measurement uncertainty
with 3-point blade
Measurement uncertainty
[1]
Notice: The vibration value indicated was determined with a standardized tool and can be used to make comparisons with other electric
equipment as well as temporary estimates of the load through the vibrations.
WARNING!
The vibration value may vary according to the usage of the machine and its fitted equipment, and be higher than the one indicated. Safety
measures must be established to protect the user and must be based on the load estimate generated by the vibrations in real usage conditions.
In this regard, all the operational cycle phases must be taken into consideration, such as switching off or idle running.
The noise level may vary according to machine usage if working or running idle.
Power supply voltage
Power supply frequency
Motor Power
Cutting width
with line cutter head
with 3-point blade
Mass
with line cutter head
with 3-point blade
Maximum tool rotation speed
with line cutter head
with 3-point blade
TECHNICAL SPECIFICATIONS
B 1.0 EJ
dB(A)
dB(A)
dB(A)
dB(A)
dB(A)
dB(A)
dB(A)
dB(A)
m/sec
2
m/sec
2
m/sec
2
m/sec
2
m/sec
2
m/sec
2
m/sec
2
m/sec
2
B 1.0 EJ
V~
Hz
W
cm
cm
kg
kg
min
-1
min
-1
82.5
3
84.6
3
93
3
97
3
1.99
1.5
2.16
1.5
2.50
1.5
2.98
1.5
230
50
1000
37
20
4.95
4.98
5500
7300