Technical Specifications - sylvac D50S Mode D'emploi

7. Technical specifications

Case
Front panel
Rear panel
Keyboards
Dimensions
Degree of IP rating
Weight of unit
Consumption
Storage temperature
Operating temperature
Dimensions (digits)
Thermal stabilization
when switch on
Resolution
Accuracy
Pin 1
Pin 2
Pin 3
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
Pin 9
In Terblend plastic (=ASA + polycarbonate) : Resistant to alcohol, gly-
cols, most oils and greases, diluted acids and water. Non-resistant to
aromatic hydrocarbons,, esters, acetones, concentrated mineral acids,
ammonia gas an its dilutions.
Polyester
Aluminium varnish
Flat with plastic dome tactile response
Width 180 mm, depth 75mm , height 50 mm
IP 40 (according to IEC 529)
0.3 kg (0.675 lb)
<250mA on Sylvac charger
from –20°C to +45°C
from +5°C to +40°C
height 13.2 mm
15 minutes minimum
0.1 μm (.00001'')
Probe P2 : 1.5μm
Probe P5 : 1.6μm
Probe P10 : 1.6μm
Probe P25 : 1.9μm
Probe P50 : 3.9μm
+0.3µm for D50S-FAST (+0.6µm for P50)
Ground
Input + 8.5 V
External contact input 1 (signal = 0 Volt)
Output charger 8.5V / 300 mA
TXD of unit = input RS 232 C of PC
RXD of unit = output RS 232 C of PC
Not used
SG = Signal ground
Not used
Not used
Not used
Output charger 8.5 V / 300 mA
18