Test Of Memory; Codes For Remote Commands - sylvac D50S Mode D'emploi

4. Test of memory

+

5. Codes for remote commands

Each retro-command must be followed by one «CR» (Carriage Return)
Code
?
'A'
ABS
'B'
BAUD 4800
BAUD 9600
BAUD 19200
BAUD 38400
BAUD ?
BEEP ?
BEEP 0 or OFF
BEEP 1 or ON
'C'
CHA+
CHA-
CHA ?
CHA 0 OR OFF
Run a test of memory.
Display FLASH........
..... PASSEd if successful test.
If display show MEM 0 Err,
The unit is still ready to measure correctly but must qui-
ckly be checked by a technical inspection.
If display show MEM 1 Err,
The unit is not ready any more to measure
Function
Sends the displayed value (1..4)
Actives the Abs mode of the indicated channel
Actives the baud rate at 4800bits/s
Actives the baud rate at 9600bits/s
Actives the baud rate at 19200bits/s
Actives the baud rate at 38400bits/s
Sends the selected baud rate
Sends the status of the buzzer
Disables the buzzer
Enables the buzzer
Selects positive measuring direction of the indicated channel.
Selects negative measuring direction of the indicated channel.
Sends the measuring direction of the indicated channel (+/-)
Lock the function +/-
13
E