Güde GH 2801 SILENT Traduction Du Mode D'emploi D'origine page 12

over 25 metres, minimum cross section is 2.5mm².
Attention! The extension cables not corresponding to the
requirements must not be used. The extension cable, plug
and socket must be water-proof and approved for outdoor
application.
Cable connections must be dry and must not rest on
ground.
If a cable drum is used, it must be unreeled.
Proceed as follows (pic.2-7):
•
Take the machine out of the package and install the
axis, transport wheels and the collection bag
(pic. 2-7).
Operation
Always put the appliance on solid and leveled surface. Do
never tilt or move the appliance if it is on and running.
Attention! The engine runs down after turning off.
Remove soil from the root balls and avoid penetration of
foreign objects such as stones, glass, metals, plastic
materials or textiles in the filling hopper and thereby to the
appliance, cutting roll; the appliance may get damaged.
The filling hopper must be empty.
Turning on
Press green Start pushbutton (Fig. 1/2)
Turning off
Press red Stop pushbutton (Fig. 1/2)
Safety feature against repeated running up
The safety feature against repeated running up prevents
sudden engine start after power supply failure.
Reverse operation
Press and hold the reverse operation button (Fig. 1/3)
depending on your model, press also green Start button
(Fig. 1/2) the cutting roll then rotates in reverse direction
and releases the clogged material.
Overload safety feature
If the appliance is exposed to excessive load (e.g. clogging
of cutting roll), the appliance halts after several seconds.
Work instructions
Material supply
Insert the shredded material only, the rotating cutting roll
will draw it in automatically.
•
Insert such quantity of material not to clog
the hopper.
•
Do not shred soft waste without solid
consistency but compost it directly.
•
Make sure the shredded material exits to the
collection box or bag without any
restrictions - danger of clogging!
•
Best results are achieved if you shred fresh
branches shortly after cutting.
Adjustment of pressure plate
The pressure plate is calibrated by the manufacturer and
requires no adjustment before first commissioning.
Adjustment of the pressure plate is required in case of
wear, e.g. when the branches wedge in chain each other
and they can not be shredded correctly.
In this case proceed as follows:
Turn the engine on and slowly rotate the adjustment knob
(Fig. 8/C) clockwise to hear slight friction. The cutting roll
sharpens the pressure plate to correct distance. Adjust the
plate so that it is not worn too early.
Identification
Product safety:
The product complies with
relevant EU standards
Prohibitions:
No pulling the plug!
Warning:
Warning/caution
Caution! Hurled objects!
Not suitable for indoor use
Commands:
General prohibition sign
Use goggles and ear
protection
Environment protection:
Dispose waste not to harm
your environment.
Defective and/or disposed
electric or electronic devices
must be delivered to relevant
collection points.
12
Protect against rain and
moisture!
Caution! Dangerous electric
voltage!
WARNING! Rotating
appliance poses the risk of
injury!
Keep bystanders in safe
distance from the
appliance.
Read operation manual
before use
Use protective gloves
Packaging material from
cardboard can be recycled
in a collection point.