EUROM E-Convect wifi Manuel D'utilisation page 35

 Remove all packaging material and keep out of reach of children. After
removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance,
but contact your vendor for inspection or replacement.
 Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
 The device has to be hung from a wall and therefore may not be used in a lying,
leaning or standing position!
Wall mounting
 Choose a firm, even, vertical wall made of heat-resistant material on which to
hang the heater.
 There are two suspension brackets on the back of the heater. Define the exact
distance between the two suspension points.
 Mark where the holes need to be drilled: do this at the correct distance and
perfectly level with respect to each other.
 Drill the holes at the marked locations and insert plugs.
 Screw two screws supplied into the plugs until they protrude by 5 mm.
 Hang the E-Convect Wi-Fi with the suspension brackets over the screws (fig. 1),
slide it as far as possible to the left and then allow it to drop (the screw goes
from A to B, see fig. 2). The spacer bracket keeps the bottom of the heater at
the correct distance from the wall.
 Now mount the safety bracket (X) onto one of the suspension brackets, mark
the screw position, drill a hole, insert a plug and screw the safety bracket
against the wall, immediately above the suspension bracket (see fig. 3).
 Your heater will now be firmly mounted and ready for use.
 To take the heater off the wall, first remove the safety bracket.
What is unique about the E-convect, is that it can be painted.
You can paint the E-convect in any color you wish, with any
water resistant paint. Do not paint the box with the switch
and remove the plug from the socket before you start
painting. Allow the panel to dry before using it again!
35