Assembly - Husqvarna 115iPT4 Manuel D'utilisation

• Stop the product before you move to another area.
Attach the transport guard before carrying or
transporting the product any distance.
• Never put the product down when it is activated
unless you have it in clear sight.
• If the product is operated at temperatures below
-10°C the product and the battery must be stored in
a heated space for at least 24 hours before starting
work.
• Never stand directly under underneath a branch that
is being cut. This could lead to serious or even fatal
personal injury.
• Observe the applicable safety regulations for work in
the vicinity of overhead power lines.
• This product is not electrically insulated. If the
product touches or comes close to high-voltage
power lines it could lead to death or serious bodily
injury. Electricity can jump from one point to another
by arcing. The higher the voltage, the greater the
distance electricity can jump. Electricity can also
travel through branches and other objects, especially
if they are wet. Always keep a distance of at least 10
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
To assemble the shaft
1. Make sure that the electrical plugs are aligned.
A
10

Assembly

B
m between the product and high voltage power lines
and/or objects that are touching them. If you have to
work within this safe distance you should always
contact the relevant power company to make sure
the power is switched off before you start work.
• A faulty cutting attachment may increase the risk of
accidents.
Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you do maintenance on
the product.
• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
2. Connect the ends of the shaft (A) fully.
3. Tighten the screw handle on the saw head side of
the shaft (B).
To adjust the length of the shaft
1. Loosen the screw handle at the battery housing side
of the shaft (A).
A
2. Adjust the shaft to an applicable length.
3. Tighten the screw handle (B).
B
707 - 003 - 04.03.2019