To Stop The Product; Maintenance; Maintenance Schedule - Husqvarna 115iPT4 Manuel D'utilisation

1. Push the SavE button. The LED comes on to show
that the function is on.
2. Push the SavE button again to stop the SavE
function.

To stop the product

1. Release the power trigger.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance work on
the product.
WARNING: Remove the battery before you
do maintenance on the product.

Maintenance

Clean the external parts of the product with a
dry cloth. Do not use water.
Make sure that the start and stop button
works correctly and are not damaged.
Make sure that the power trigger and the
power trigger lockout function correctly from
a safety point of view.
Make sure that all controls work and are not
damaged.
Keep the handles dry and clean. Makes sure
that that there is no oil and grease on the
handles.
Make sure that the saw chain cover is not
damaged. Replace the saw chain cover if it is
damaged.
Make sure that the screws and nuts are tight.
Clean the oil tank cap
Make sure that the battery release buttons
on the battery works and locks the battery in
the product.
707 - 003 - 04.03.2019
2. Push and hold the stop button until the green LED
light goes off.
3. Remove the battery from the product. Push the 2
release buttons and pull out the battery.
Maintenance

Maintenance schedule

The following is a list of the maintenance steps that you
must do on the product. Refer to the tasks in the
maintenance chapter for more information.
Daily
X
X
X
X
X
X
X
X
X
WARNING: Remove the battery before you
do maintenance.
Weekly Monthly
13