Getting Started - Alpine iDA-X200 Mode D'emploi

Getting Started

iDA-X200
Double Action encoder
SOURCE /ENTER
iDA-X300
Rotary encoder
SOURCE
/ENTER
Accessory List
• Digital Media receiver........................................................1
• Power cable ........................................................................1
TM
• FULL SPEED Connection Cable
(iDA-X300 only) ..................................................................1
• USB cable (iDA-X200 only)................................................1
• iPod Dock interface cable (iDA-X200 only)......................1
• Mounting sleeve.................................................................1
• Carrying case .....................................................................1
• Bracket key.........................................................................2
• Screw (M5x8)......................................................................4
• Owner's Manual .......................................................... 1 set
Turning Power On and Off
Press SOURCE to turn on the unit.
• The unit can be turned on by pressing any other button except
(Release), Double Action encoder (iDA-X200 only) and VIEW.
The unit is also automatically turned on if a USB memory is
connected.
Press and hold SOURCE for at least 2 seconds to turn
off the unit.
• The first time power is turned on, the volume will start from level 12.
Detaching and Attaching the Front Panel
Detaching
1
Turn off the unit power.
2
Press (Release) at the middle left side until the
front panel pops out.
3
FUNC./SETUP
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel.) This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
Attaching
1
VIEW
FUNC./SETUP
2
VIEW
• Before attaching the front panel, make sure that there is no dirt or
dust on the connector terminals and no foreign object between the
front panel and the main unit.
• Attach the front panel carefully. Hold the panel by its sides to avoid
pushing any buttons by mistake.
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first
time, after changing the car battery, etc.
1
2
3
Adjusting Volume
Turn the Double Action encoder (iDA-X200 only) or
Rotary encoder (iDA-X300 only) until the desired
sound is obtained.
Grasp the left side of the front panel and pull it out.
Insert the right side of the front panel into the main
unit. Align the groove on the front panel with the
projections on the main unit.
Push the left side of the front panel until it locks
firmly into the main unit.
Turn off the unit power.
Press (Release) to remove the front panel.
Press RESET with a ballpoint pen or similar pointed
object.
7
-EN