Welding; Maintenance And Cleaning - Parkside PISG 120 A2 Consignes D'utilisation Et De Sécurité

Using the device / Welding / Maintenance and cleaning
again you must first remove the welding
slag at the welding position.
ATTENTION!
A voltage which is 10% below the rated
input voltage of the welding device can
have the following consequences:
The power to the device will reduce.
„
The arc stops or becomes unstable.
„
z Welding
Choose between push and drag welding. The following section shows the impact of
the direction of movement on the properties of the weld seam:
Burn
Weld seam width
Weld bead
Weld seam fault
Note: You decide for yourself which
type of welding is most suitable, once
you have welded a sample piece.
Note: Once it has worn down com-
pletely, the electrode must be replaced.
38 GB/IE
ATTENTION!
The arc radiation can lead to inflam-
„
mation of the eyes and skin burns.
Casting and welding slag can cause
„
eye injuries and burns.
Wear tinted safety goggles or a
„
protective mask.
The safety mask must meet the
„
EN175 safety standards.
It is essential that you only use the
„
welding cable which is included with
the delivery (10 mm
Push welding
smaller
larger
flatter
larger
z Maintenance and
cleaning
Note: The welding device must be
regularly serviced and overhauled for
proper function and for compliance with
the safety requirements. Improper and
wrong operation may cause failures and
damage to the device.
Before performing cleaning work on
„
the welding tool, disconnect the
power cable
).
2
Drag welding
larger
smaller
higher
smaller
from the power
10