Lovibond Tintometer SD 305 pH/ORP Mode D'emploi page 44

Set output: Setting of universal output
(Out = SEr)
(Out = dAC)
(Out = dAC)
Set correction: Adjustment of measurements
(mV)
(%)
(°C / °F)
(%)
44
Universal output
oFF Interface and analogue output off
(lowest possible power consumption)
SEr Serial interface activated
dAC Analogue output activated
01.11 ... 91 Base address of the instrument
for serial interface communication
e.g. pH 1.00 Entry of the measurement value
at which the analogue output must
output 0V
e.g. pH Entry of the measurement value
13.00 at which the analogue output must
output 1V
Zero point correction / offset of the voltage
measurement
oFF No zero point correction
-10.00 ... Zero point correction in mV
+10.00
Slope correction of the voltage measurement
oFF No slope correction
-5.000 ... Slope correction in %
+5.000
Zero point correction / offset of the
temperature measurement
oFF No zero point correction
-5.0 ... +5.0 Zero point correction in °C
Slope correction of the temperature
measurement
oFF No slope correction
-5.00 ... Slope correction in %
+5.00
SD_305_pH/ORP_1 04/2021