Mounting Instructions - CDVI Digicode Série Manuel D'installation

INSTALLATION MANUAL
PROFIL100EC
Illuminated Mullion Weatherproof Keypad with Remote Electronics

4] MOUNTING INSTRUCTIONS

Once you have made sure that the mounting kit is complete and that you prepared the cables
of the PROFIL100EC keypad and its remote electronic then you can proceed and mount the
product. Make sure that you have all the appropriate tools (drill, screw drivers and a meter
tape...) and follow the mounting instructions for the PROFIL100EC and its remote electronic.
1
Verify the
between the PROFIL100EC
keypad and its
electronic (refer to page 3,
Notes and Recommendations).
Place the back plate of the
PROFIL100EC on the wall and
the bracket of the
electronic then mark with a pen
the hole location then drill the
2 mounting holes (5mm drill
bit Ø and 35mm hole depth)
and the hole wiring access.
4
cdvi.com
12 12
cdvigroup.com
2
distance Insert the 2 plastic anchors
in the holes. Mount the back
remote plate of the PROFIL100EC with
the (M4x30) mounting screws.
remote
5
Insert the 2 plastic anchors
in the holes. Place the bracket
of the
on the wall using the supplied
M4x30 screws. Slide the box
from up to down on the bracket.
electronic and screw
3
Insert the cable in the hole
access area of the back plate.
Then mount the keypad on
the back plate, placing fi rst
the top in the hooks and then
the bottom.
6
EN