Wiring Diagram - CDVI Digicode Série Manuel D'installation

INSTALLATION MANUAL
PROFIL100EC
Illuminated Mullion Weatherproof Keypad with Remote Electronics

5] WIRING DIAGRAM

P3 jumper allows to the
user
Pin code. To enable this
feature put the jumper on.
(see Programming section
in the instruction manual)
P2 jumper
to factory default values. Remove
the power from the keypad then put
the jumper. (see Programming section
in the instruction manual)
Outputs
V
Input voltage 12V to 24V ac or 12V to 48V dc
V
Input voltage 12V to 24V ac or 12V to 48V dc
R1
N/C contact relay 1
C1
Common relay 1
T1
N/O contact relay 1
R2
N/C contact relay 2
C2
Common relay 2
T2
N/O contact relay 2
P1
Request-to-exit input relay 1
M
Common of inputs
P2
Request-to-exit input relay 2
PX
Request-to-enter input
H
Timer Contact
+
White wire from keypad
-
Brown wire from keypad
E
Green or Blue wire (illumination)
to modify its own
resets the keypad
Input voltage
12 to 24V ac
or 12 to 48V dc
Power supply
According to lock
specifi cations
Description
D - 693: Remote electronics
Relay Relay
1 2
Fail safe lock
Fail secure lock
Varistor
Request-to-Exit inputs
- P1 request-to-exit input
activates relay 1.
- P2 request-to-exit input
activates relay 2.
- Latch or toggled output.
H input can be used with
a timer to enable the
request-to-enter function.
(Press the button on the
keypad with the key logo
When the contact is open then
the request-to-enter is disabled.
When the contact is closed then
press the button with the key
logo to enter.
EN
cdvi.com
13 13
cdvigroup.com