General Information; Mounting Kit - CDVI GALEOW Manuel D'installation

INSTALLATION MANUAL
GALEOW
Wiegand illuminated keypad

1] GENERAL INFORMATION

Output formats:
- Wiegand,
- Standard format,
- ISO Track 2 format.
Back-lighted.
Material: Cast aluminium alloy.
Visual and audible signalling.
Surface mounting.
Small size.
Torx screw assembly.
®
Totally waterproof (cast body).
Dimensions (L x W x D): 110 x 75 x 15 mm.
Rear switch on the GALEOW for entry to
and exit from programming mode.
Permanent E2PROM memory back-up.
Number of digits: 4, 5 or 6.
Operating voltage: 12 V DC.
Consumption: 100 mA max.
2] NOTES AND RECOMMENDATIONS
Wiring reminder
- In the case of direct connection to the CT-V900-A
(CENTAUR) central controller or one of the
LINKNET door controllers, the GALEOW must be
installed within a maximum distance of 50 m.
- In other cases, the distance between the GALEOW
and the (INTBUSW) door controller must be within a
maximum of 50 m and the distance between the
central controller or panel and the last (INTBUSW door
controller may be up to 1200 m maximum.
- Take care not to pass your wires close
to «High voltage» cables (e.g.: 230 V AC).
Recommended cables
2 pairs of cables (4 strand) SYT1 8/10ths (Shielded
cables - AWG 20).

3] MOUNTING KIT

GALEOW
cdvi.com
12
cdvigroup.com
Torx screw
®
Varistor
(M4x10)
1 1
WEEE & RoHS
IP64
CE Certifi cation
Envrionmental tests:
vibrations
-25°C to +70°C
Fitting
To optimise the mounting of the GALEOW and to combat
attempted tampering, it should be fi tted on a fl at surface.
Recommended power supplies
- A power supply independent of the central controller
is necessary for the GALEOW.
- There are two suitable power supplies for this
Digicode keypad: ARD12 or BS60
®
Installation recommendations
To protect the installation, remember to:
- install the varistor in parallel on the locking
system power supply side,
- install a 120 ohm resistor between A and B
on the last BUS RS485 door controller.
T20 Torx
®
Cap
spanner
1 2
mounting
S5 plastic
screw
anchor
(M4x30)
2 2