Introduction; About This User Guide; About Your Product - Rimage Producer III 8100N Mode D'emploi

Introduction

This manual provides the information needed to operate, identify the parts of, and configure the printing preferences for
the Rimage® Producer™ 8100N, 7100N, 6100N, and 6100. These products are part of the Rimage Producer IIIN and III series
of products. The terms 'Producer III' and 'autoloader' are used throughout this document to refer to these products.
To set up and install your Producer III, refer to the setup and installation guide included with your product.

About this User Guide

• While we try to maintain all versions of our manuals and documentations, please note that the English version found on
our website always contains the most up-to-date information.
• Unless otherwise indicated, all Windows navigation statements are Windows XP paths. Windows Vista, Windows 2000
and Windows Server 2003 navigation may differ slightly.
• These symbols are used throughout the manual to help clarify information:

Note: A Note provides supplemental information or information that may apply only in special cases. For example,
memory limitations, equipment configurations, or details that apply to specific versions of a program would be
included in a Note.
Tip: A Tip provides techniques and procedures to help with your specific needs. A Tip suggests alternative methods
that may not be obvious and helps you understand the benefits and capabilities of the product.
-
Important! An Important note provides information essential to the completion of a task. You can disregard
information in a Note or Tip and still complete a task, but do not disregard an Important note.
n
Caution: A Caution indicates that failure to observe this guideline could result in loss or damage to the equipment,
product, software, or data.
, Warning! A Warning indicates that failure to follow this guideline could result in bodily injury to personnel
operating or maintaining the equipment.

About Your Product

The Producer III is available with either the Everest™ III or 600 printer, or the PrismPlus!™ printer. For information about
your printer, refer to the setup and installation guide or user guide that shipped with your printer.
The Producer 6100N, 7100N, and 8100N autoloaders have an embedded control center (PC). The embedded PC is a
network-ready device that receives orders from other networked computers. You can also operate the Producer 6100N,
7100N, and 8100N locally by attaching a monitor, keyboard, and mouse.
The Producer 6100 requires an external PC to be used as the external control center. In most instances, the Producer 6100
autoloader is not shipped with an external PC. You must provide a PC to be used as the external control center. The
section on page 6 provides the minimum and optimum PC requirements for the 6100.
III Specifications
2001475_A
Introduction
Producer
1