Install The Carousel; Remove The Carousel - Rimage Producer III 8100N Mode D'emploi

Install the Carousel

Tip: To prevent errors, install the carousel before operating the software or powering on the autoloader.
Open the front door.
1.
Install the carousel in the Producer III.
2.
Slide the carousel straight in so that the center post slides through the slot opening of the bearing guide.
a.
b. Rotate the carousel until the top support bearing lowers into the bearing guide.
Close the front door.
3.

Remove the Carousel

Remove the carousel from the autoloader to load or unload discs.
-
Important! If the Rimage software is currently running an operation on the autoloader, wait for the software to
complete the operation, or pause the software operation before removing the carousel.
Open the front door.
1.
Grasp the bottom of the carousel with two hands.
2.
3. Lift the carousel off the carousel platter until the top support bearing clears the bearing guide.
4. Move the carousel out of the autoloader.
2001475_A
Operate the Producer III
Bearing Guide
Center Post
Top Support Bearing
13