Rimage Producer III 8100N Mode D'emploi page 22

5. Open the top access cover.
Tip: Look down through the top opening to observe the
printer alignment.
Align the printer.
6.
Slowly move the lift arm down until the disc touches the recessed print pad.
a.
Printer Button
Side to Side Alignment
b. If the disc is not centered side to side on the print pad, align the printer side to side.
i. Loosen the side to side screws.
ii. Slide the printer, not the printer tray, until the disc is centered side to side on the print pad.
iii. Tighten the side to side screws.
Front to Back Screw
2001475_A
Print Pad
Side to Side Screws
Maintain the Producer III
Top Access Cover
Lift Arm
Holding Pins
21