Parts Information; Status Light; Operator Panel; Operator Button - Rimage Producer III 8100N Mode D'emploi

Parts Information

Status Light

The Producer III can be equipped with an optional status light that indicates various conditions. The table below illustrates
status light states and explains the conditions indicated by each state.
Light State
Green light
on
Green light
blinking
Yellow
light on
Yellow
light
blinking
Red light
on

Operator Panel

The operator panel has a two-line display that informs you of operations or conditions that require operator intervention,
including the consumable status. After initialization, the Producer IIIN displays the name of the embedded PC. Refer to the
section on page 23 to see other options.
Operate Gemini Utilities

Note: The caret symbol '^' in the upper right corner of the operator panel indicates that the Rimage software is
currently communicating with the autoloader.

Operator Button

Open the front door to access the operator button. Press the operator button to rotate the carousel and position a bin so
that discs can be loaded or unloaded. Each time you press the operator button, the carousel rotates to the next bin.
Tip: The carousel will rotate to a bin only after the autoloader has completed initializing.

Disc Dispenser (6100, 6100N, and 8100N Only)

The disc dispenser moves discs into the output bin. Only the 6100, 6100N, and 8100N have the disc dispenser and output
bin.

Beeper

The Producer III has a beeper that sounds when user intervention is required. Read the error message that displays on the
operator panel or on your PC monitor and take appropriate action to correct the problem. Refer to the
section on page 23 for beeper settings.
2001475_A
System Condition
The system is operating properly. No jobs are currently processing.
The system is operating properly. Jobs are currently processing.
The autoloader is waiting for the software to start. If the control center is not started, power
on the control center. Check the cable connections on the autoloader and control center.
The front door may be open. Close the front door to allow jobs to process.
The print ribbon or media may be running low. Read the operator panel to determine which
supply is running low.
The carousel is out of blank discs. Fill the supply bins with the appropriate media type.
A system error requires operator intervention. Check the client workstation or control center
for a message.
An equipment error occurred at initial start up, such as a missing carousel. Check the client
workstation or control center for a message.
Identify the Parts of the Producer III
Enable the Beeper
11