Operate The Producer Iii; Power On The Producer Iii; Power Off The Producer Iii; Pause The Producer Iii - Rimage Producer III 8100N Mode D'emploi

Rimage Producer™ III User Guide

Operate the Producer III

This section provides the information that you need to produce discs with the Producer III.

Power On the Producer III

Before you begin:
The carousel must be installed before you power on the system. For more information about installing the carousel, refer to
the Install the Carousel section on page 13.
Press the power switch on the rear of the autoloader. The Producer III powers on.
1.
• If you have a Producer 6100N, 7100N, or 8100N, continue with step 2.
• If you have a Producer 6100, the system is powered on.
2. On the front of the autoloader, press the PC power button to power on the embedded PC. The autoloader and
embedded PC power on.
Power Switch

Power Off the Producer III

1. Close all open applications.
• If you have a Producer 6100, continue to step 3.
• If you have a Producer 6100N, 7100N, or 8100N, continue to step 2.
Briefly press the PC power button. This shuts down the software, Windows, and the embedded PC.
2.
n
Caution: Do not press and hold the PC power button. If you press and hold the PC power button, the embedded PC
will not shut down properly. This may cause data loss or corruption.

Note: It takes approximately 30 seconds for the system to power off.
Press the main power switch to power off the Producer III.
3.
-
Important! If you have a Producer 6100N, 7100N, or 8100N, do not press the main power switch until the
embedded PC is completely powered off.

Pause the Producer III

Pause the Producer III to add discs to the autoloader.
Open the front door. The operation pauses.
1.
Close the front door. The operation resumes.
2.
12
7100N/8100N/6100N/6100
PC Power Button
(6100N, 7100N, and 8100N Only)
2001475_A