Using The Converter - Dometic PerfectCharge DC 08 Instructions De Montage Et De Service

Using the converter

8 Using the converter
You can switch on the device as follows, depending on the connection:
• Using the main switch on the device (fig. 1 6, page 3)
• Using the ignition (fig. 5 A, page 4)
Terminal 15: Connected positive terminal
• Using an external switch (fig. 5 B, page 4)
Switching on the converter
➤ Set the main switch (fig. 1 6, page 3) on the back of the converter to "1" ...
... or start the ignition ...
... or push the external switch.
✓ The LEDs (fig. 1 3 to 5, page 3) indicate the operating status:
LED
Power On
Battery Low
Overload
I
NOTE
The internal fan is operated according to the temperature. It only runs
when the temperature is too high. During this time the converter is
switched off to prevent overheating.
16
Colour Explanation
Green The device is switched on and there is voltage at
the output terminals on the converter. The
converter is ready for use.
Yellow The input battery is no longer sufficiently
charged.
➤ Recharge the battery or use a charged
Red
If a consumer is connected:
The converter is shorted or overloaded.
➤ Eliminate the short circuit or reduce the
If connected as a charger:
The converter is in the full current charging
phase.
PerfectCharge/PerfectPower
battery.
output load.
EN