Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Ventilation condition
Make sure the refrigerator is placed in an area with adequate ventilation and is not exposed to hot air. Do not
locate the refrigerator near a heat source such as cooker, and avoid it from direct sunlight, thus guaranteeing
the refrigeration effect while saving energy consumption. Do not locate the refrigerator in the damp place, so
as to prevent the refrigerator from rusting and leaking electricity. The result of the total space of the room in
which the refrigerator is installed being divided by the refrigerant charge amount of the refrigerator shall not be
less than 8 g/ m³.
Note: The amount of refrigerant charged for the refrigerator can be found on the nameplate.
Heat dissipation space
When working, the refrigerator gives off heat to surroundings. Therefore, at least 300mm of free space should
be spared at the top side, more than 100mm on both sides, and above 50mm at the back side of the refrigerator.
Dimensions in mm:
W
D
839
637
Note: figure 1 and figure 2 only illustrate the space demand of the product.
FIRST USE
Adjust the feet and clear the outside and inside of the refrigerator with warm cloth.
Do not start the refrigerator immediately after vertical placement. Only start it after 2-6 hours standing to ensure
its proper operation.
To prevent damage to the power cord and any consequence incidents, the power cord should not be covered
by the refrigerator or other objects. Before switching on the refrigerator, please check the voltage range of the
refrigerator carefully if the same as that of the power supply.
When the refrigerator is first installed, allow it to stabilize at normal operating temperatures for 2-3 hours prior
to filling it with fresh or frozen foods.
If operation is interrupted, wait for 5 minutes before restarting.
Insert the plug into the solid socket to start the compressor. After 1 hour, open the freezer door, if the
temperature inside the freezer compartment drops obviously, it indicates the refrigeration system is working
normally.
After the refrigerator runs for a period of time, the internal temperature of the refrigerator will be automatically
controlled according to the user's temperature setting. After the refrigerator is fully cooled, put in foods, which
usually need 2-3 hours to be fully cooled. In summer, when the temperature is high, it takes more than 4 hours
for the foods to be fully cooled (Try to open the refrigerator door as less as possible before the internal
temperature cools down).
If the refrigerator is installed in the moisture place, make sure to check whether the ground wire and leakage
circuit breaker are normal. If vibration noises are produced due to the refrigerator contacting the wall or if the
wall gets blackened by air convection around the compressor, move the refrigerator away from the wall. Setting
up the refrigerator may cause jamming noise or image chaos to the mobile phone, fixed-line telephone, radio
receiver, television set surrounding it, so try to keep the refrigerator as far away as possible in such case.
H
A
1763
1447
B
C (°)
E
1013
140
50
- 8 -
F
100
Publicité
Table des Matières
