Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. Open the refrigerator door to ensure the water dispenser is fixed well.
2. Open the filler cover (a) of the water tank (b), slowly fill the water tank to prevent any spills until the tank is
filled. Then close the filler cover of the water tank.
3. Once the water tank is full, set the refrigerator compartment at the lowest temperature, and one hour later
you can dispense water for drinking by pushing the water switch (c).
4. When using the water dispenser, some water may drip and accumulate at the bottom of the water dispenser.
Please wipe it with a cloth when necessary.
5. The maximum fill must be lower than the tank cover (d) as indicated by the maximum fill line.
Note: Don't take away the cup until no waterdrop.
CLEANING AND CARE
Before cleaning, unplug the power plug first. Do not plug in or plug out the plug with wet hand, because there
is a risk of electric shock and injury. Do not spill water directly on the refrigerator, to avoid rust, electricity
leakage and accidents. Do not stretch your hands into the bottom of the refrigerator, since you might be
scratched by sharp metal corners.
Exterior cleaning
•
To maintain good appearance of your appliance, you should clean it regularly.
•
Spray water onto the cleaning cloth instead of spraying directly on the surface of the appliance. This helps
ensure an even distribution of moisture to the surface.
Caution! Don't use sharp objects as they are likely to scratch the surface. Don't use Thinner, Car detergent,
Clorox, ethereal oil, abrasive cleansers or organic solvent such as Benzene for cleaning. They may damage the
surface of the appliance and may cause fire.
Interior cleaning
You should clean the appliance interior regularly. It will be easier to clean when food stocks are low. Wipe the
inside of the fridge freezer with a weak solution of bicarbonate of soda, and then rinse with warm water using
a wrung-out sponge or cloth. Wipe completely dry before replacing the shelves and baskets. Thoroughly dry all
surfaces and removable parts.
Caution! Make sure that no water enters into lamp hood and other electric parts.
Caution: Do not use bristle brush, steel wire brush, detergent, soap powder, alkaline detergent, benzene,
gasoline, acid, hot water and other corrosive or soluble items to cleanse the cabinet surface, door gasket, plastic
decorative parts, etc., so as to avoid damage.
Carefully wipe dry the door gasket, clean the groove using a wooden chopstick wrapped with cotton string. After
the cleaning, fix the four corners of the door gasket first, and then embed it by segment into the door groove.
Replacing the LED light
Warning: the LED light must not be replaced by the user! If the LED light is damaged, contact an authorized
service representative for repairing.
- 14 -
Publicité
Table des Matières
