Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2)
Enabling the fast freeze function
Press the function button to select Fast freeze until the corresponding icon gets flickering, and then press
the OK button within 5s for confirmation. If the OK button is not pressed within 5s, the setting will be
invalidated.
3)
Exiting the fast freeze function
After a cumulative running period of 26 hours, the fast freeze function will exit automatically.
Under the fast freeze mode, press the function button to select Fast freeze until the corresponding icon
gets flickering, and then press the OK button for confirmation, the fast freeze function will get exited.
When the smart function is enabled, the fast freeze function will be disabled automatically.
3.
Smart function
1)
When the smart function is enabled, the temperature of the refrigerator compartment is controlled at 5℃,
and that of the freezer compartment at -18℃, so that foods can be stored in the best condition while the
refrigerator is running more efficiently and with better performance.
Caution: Under the smart mode, the refrigerator compartment temperature and the freezer compartment
temperature are subject to no change.
2)
Enabling the smart function
Press the function button to select Smart until the corresponding icon gets flickering, and then press the
OK button within 5s for confirmation. If the OK button is not pressed within 5s, the setting will be invalidated.
3)
Exiting the smart function
Under the smart mode, press the function button to select Smart until the corresponding icon gets flickering,
and then press the OK button for confirmation. The smart function will get exited.
When the fast freeze function is enabled, the smart function will be disabled automatically.
4.
Child lock
1)
When the child lock function is enabled, the temperature and function are subjected to no change to
prevent maloperation.
2)
In case of no button operation within 3 minutes, the child lock function will be enabled automatically.
3)
Exiting the child lock function manually:
Press and hold down the unlock button for 3s, then the child lock function can be disabled.
5.
Door open alarm
If any door is open for more than 3 minutes, buzzer alarms will be continuously issued, which can be stopped
when any button is pressed, but will be restored after 3 minutes if the door keeps open. The alarms will not be
lifted until the door is closed.
6.
Power cut memory
In the case of power failure, the refrigerator will maintain the running state that is set before the power outage
when the power supply is restored.
7.
Power-on delay
In order to protect the refrigerator compressor from being damaged in the case of short-time power failure (i.e.,
less than 5 minutes), the compressor will not be started immediately after it is powered on.
8.
Over-temperature alarm (only after power outage)
When the refrigerator system is powered on, if the freezer sensor temperature is higher than -10℃, the freezer
zone gets flickering on the display. The freezer temperature can be displayed when any button is pressed, and
the normal display will be restored when any button is pressed again or after 10s.
9.
Fault alarm
In case E0, E1, E2, EH, or EC is displayed on the operation panel, it indicates fault with the refrigerator. Please
contact the after-sale service.
Note: the temperature will impact the storage time of food. Set the temperature as necessary. Warmer will
accelerate food spoilage and colder will freeze food bad. Thus, food to be wasted.
- 10 -
Publicité
Table des Matières
