Fitting The Backrest; Adjusting The Backrest Cover - Invacare Aquatec Ocean Mode D'emploi

Shower and Toilet Commode Ocean / Ocean XL

Fitting the backrest

1. Secure all four wheels. To do this, press down on the red foot lever
on the wheels.
!
IMPORTANT
▸ Ensure that the armrests point forward when in the unfol-
ded position.
2. Insert the backrest from behind into the seat frame E, until the
D
collar abuts the seat frame tube F.
C
!
IMPORTANT
▸ The rounded part of the curved washers must sit on the
seat frame tube.
▸ Firmly tighten the screws using the Allen key supplied. The
torque is 5 Nm.
▸ Check the screws regularly to ensure they are sitting
securely.
3. Position a curved washer
rest, on the left and right, with two screw on each side.
8
on each screw and secure the back-
B A

Adjusting the backrest cover

The tension of the backrest can be adjusted as desired.
Tightening
1. Pull the belts of the backrest cover tighter.
A
Loosening
1. Open the buckles by squeezing the retaining lugs together
B
(arrows).
2. Push the belts back a little through the buckle.
3. Close the belt buckles.
4. Retighten the belts gently.
Assembly and installation