Environmental Protection; Repair Service - IKRA GHTI 50 Manuel D'utilisation

Environmental protection

If this hedge trimmer should some day have been used
in such an intensive way that it must be replaced or you
do not have any use for it any longer, please think of
the protection of the environment. Electrical devices,
accessories and packaging do not belong to your do-
mestic refuse, but should be supplied for environmentally
friendly recycling in accordance with the applicable local
regulations.

Repair service

Repairs to electric power tools should only be carried out
by specialist electrical personel.
Warranty
For this electric tool, the company provides the end user
- independently from the retailer's obligations resulting
from the purchasing contract - with the following war-
ranties:
Troubleshooting
Problem
Unit does not run
Blade cutter is running hot
Blade cutter will not move
Excessive vibrations/noise
Pole trimmer operates intermittently
The warranty period is 24 months beginning from the
hand-over of the device which has to be proved by the
original purchasing document. For commercial use and
use for rent, the warranty period is reduced to 12 months.
Wearing parts and defects caused by the use of no fitting
accessories, repair with parts that are not original parts
of the manufacturer, use of force, strokes and breaking
as well as mischievous overloading of the motor are
excluded from this warranty. Warranty replacement does
only include defective parts, not complete devices. War-
ranty repair shall exclusively be carried out by authorized
service partners or by the company's customer service.
In the case of any intervention of not authorized person-
nel, the warranty will be held void.
All postage or delivery costs as well as any other subse-
quent expenses will be borne by the customer.
Possible Cause
Power cord not connected
Lock off not fully operated
Blade cutter dull
Blade cutter has dent
Too much friction, due to lack of
lubricant
Machine defective
Machine defective
Internal wiring of machine damaged
On/Off switch defective
GB-13
Possible Solution
Check power supply connection
Check that lock off is fully forward
prior to moving trigger
Have blade sharpened
Have blade inspected/ overhauled
Apply lubricant spray
Contact Service Agent
Contact Service Agent
Contact Service Agent
Contact Service Agent