Set-Up And Operation; Safety Features - EUROM RAD 2000 Oilfree Manuel D'utilisation

Return the heater to its upright position, wheels down.

Select a suitable location for the device taking into account all the

aforementioned warnings in this manual.
Warning: only use the heater when it is in an upright position, with the
wheels attached to the bottom (as pictured on the front of this booklet).
Any other position is dangerous!

Set-up and operation

Make sure that both power buttons are set to off (not pressed in) and turn the

thermostat knob as far as possible towards +.
Now insert the plug into the socket.

Operate the heater by pressing one or both power buttons: 1 button pressed =

1000 W, both buttons pressed = 2000 W. The heater will start working and the
check light will burn. To heat up slowly, for a slight
temperature increase or in a small space, press one
button (1000 W). To heat up quickly, for a larger
temperature increase or in a larger space, press both
buttons (2000 W).
Once the space has reached the right temperature,

turn the thermostat dial to - until you hear a click.
The light goes out and the heater shuts down. If you
leave the dial in this position, the heater will maintain
the current temperature by regularly switching on and
off. When the heater is switched on, the light will go
on. By turning the thermostat dial to the left/right,
you increase/decrease the set temperature.
If so desired, you can now switch to a lower power

level.
To switch off, press the depressed power button(s) again. The button(s) will

come up again. The heater switches off. Unplug.
Note! It takes some time for a radiator to cool down. Give the radiator sufficient

time to cool down before touching or moving (use handle!).
Attention! The lamp only burns if the thermostat has switched on the heating

elements!

Safety features

The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. When the heater is returned to its upright
position, it will resume functioning as normal but, before reusing, switch off, unplug
and check for damage. Do not use the heater if it is damaged or malfunctioning,
but have it inspected/repaired! In case of internal overheating, the overheating
safeguard will switch the heater off. This may occur if the heater cannot give off
29