Cleaning; Troubleshooting - SilverCrest SHT 2000 A1 Mode D'emploi

RP75978 Heiztower LB1 Seite 63 Mittwoch, 29. August 2012 3:44 15
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning! To avoid the danger of
an electric shock or burning:
– remove the mains plug before
each clean;
– allow the appliance to cool
down;
– never immerse the appliance in
water;
– never allow water or cleaning
agent to run into the appliance.
1. Carefully remove major dust deposits in
the air outlet grille 4 with a vacuum
cleaner.
2. Remove any remaining dirt with a soft
brush.
Fault
Appliance cannot be
switched on
Appliance cannot be
switched off
Appliance switches
off automatically
SHT 2000 A1

7. Cleaning

3. Take off the air intake grille 9.
4. Clean the dust off the air intake grille 9
5. Clean the outside of the appliance with
6. Wipe the appliance with a cloth
7. Do not use the appliance again until it

8. Troubleshooting

Cause
Faulty fuse or wall socket
Faulty appliance
Faulty electronic components Have repairs carried out at a specialist
Safety switch has triggered
Thermal cut-out has
triggered
Take care not to let any dust fall inside
the appliance.
and the filter grille located behind it.
a damp cloth. You could also use a little
washing-up liquid.
Caution! Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.
moistened with clear water.
has dried completely.
Remedy
Select another wall socket
Have repairs carried out at a specialist
workshop or dispose of the appliance.
You will find the service address in
"Service Centre" on page 66.
workshop or dispose of the appliance.
You will find the service address in
"Service Centre" on page 66.
Set the appliance upright (see
"6.9 Safety switch" on page 62)
Allow the appliance to cool down (see
"6.8 Thermal cut-out" on page 62)
Clean the appliance (see
"7. Cleaning" on page 63)
63