Cleaning; Cleaning The Dust Filter; Cleaning The Appliance - SilverCrest SKHD 1800 A1 Mode D'emploi

RP90873 Keramikheizlüfter LB1 Seite 51 Donnerstag, 27. Juni 2013 5:48 17
6. Plug the mains plug into a wall socket
that complies with the technical data.
Note:The appliance consumes up to
9 amperes of current (1800 watts). If
you have plugged
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning! To avoid the danger of
an electric shock or burning:
– Remove the mains plug before
each clean.
– Allow the appliance to cool
down.
– Never immerse the appliance in
water.
– Never allow water or cleaning
agent to run into the appliance.

6.1 Cleaning the appliance

1. Carefully remove major dust deposits in
the air outlet grille 7 with a vacuum
cleaner.
2. Remove any remaining dirt with a soft
brush.
Take care not to let any dust fall inside
the appliance.
3. Clean the outside of the appliance with
a damp cloth. You could also use a little
washing-up liquid.
Caution! Never use caustic or abrasive
cleaning agents, as they could damage
your appliance.
4. Wipe it off with clean water.
5. Do not use the device again until it is
fully dry.
SKHD 1800 A1
consumers into the same circuit, check
that the maximum load for the installed
fuse is not exceeded, as otherwise the
fuse will trip.
other power

6. Cleaning

6.2 Cleaning the dust filter

1. To remove the air inlet grille 9, press the
locks 8 downwards.
2. Remove the dust filter 10.
3. Clean the dust filter 10 and air inlet
grille 9 under running water.
4. Allow the dust filter 10 and air inlet
grille 9 to dry thoroughly.
5. Replace the dust filter 10 and air inlet
grille 9.
Warning! To avoid the risk of fire:
– Clean the dust filter 10 regularly.
A clogged dust filter could cause
a build up of heat.
– Never use the fan heater without
a dust filter, otherwise dust might
gather on the heating elements
and catch fire.
51