ATT Nussbaum SMART LIFT 2.30 Manuel D'exploitation page 98

Alternative lifting position
Swivel in the carrier arm and pull out properly to the
desired length.
The adjustable receiving plates must be placed at
the points specified by the vehicle manufacturer.
98
Version with MINI-MAX lifting arms
Figure 1: Position carrier plate below the fixture points approved
by the vehicle manufacturer
Figure 2: If required, place the carrier plate by pushing the lever
at the fixture points
Ensure that the ratchet is securely locked into
!
the intended position. Otherwise the "MINI-
MAX" can sink to its lowest position.
Figure 3: To release the fixture plate, the rear lever must be
pushed.
• The lifting arm block must be ratcheted in after
the fixture point has been reached.
• After each set down of the vehicle, check the lift-
ing arm positions below the fixture points again
and adjust as required.
• Check that there are no people or objects in the
hazardous area of the lift.
OPI_SMART LIFT 2.30 SL-2.35 SL-2.40 SL_V3.1_DE-EN-FR-ES-IT