Cleaning And Care - Toto Europe GmbH Mode D'emploi

GB
Power supply
Sensor detection range
Water supply pressure
Water supply connection
Ambient temperature
Flow rate
Normal mode
• (Water comes out when you hold out your hand.)
• (Water stops when you withdraw your hand.)
• The mode shown below can be engaged by changing the DIP switches of the controller.
Continuous water spouting mode
If you trigger sensor detection for 3 sec. or longer, water spouts for 1 min. at a maximum.
If you trigger sensor detection again, water stops spouting.
Cleaning mode
If you hold your hand over the sensor for 10 sec., the indication lamp turns off for 5 sec. If you leave your
hand over the sensor while the indication lamp is off, no water is discharged for a maximum of 1 min.
If you trigger sensor detection again, water spouts.
Cold water priority mode
This function prevents the wasteful use of hot water. Even after the hot water is used, this function returns to
the "Cold water mode".
Equipment protection wash
If no one uses the product for 24 hours since it was used the last time, water spouts automatically for 5 sec.
Little water spouts.
A
1. Pull out the power plug and remove the two
screws.
2. Dismount the four parts.
3. Remove the spacer and the mesh.
4. Scrub the mesh gently with a tooth brush.
5. Mount the parts in the reverse order in which they
were dismounted.
6. The mesh and the flow-dividing plate must be
assembled in a specific order.
Clean the parts regularly to prevent the accumulation of
dirt and lime-scale.
For daily cleaning use neutral cleaner.
Acids are necessary ingredients of cleaning materials for
removing lime, however please pay attention to the
following points when cleaning fittings:
Only use cleaning materials, which are explicitly provided
for this type of application.
Never use cleaning materials, which contain hydrochloric,
formic or acetic acid, as they cause considerable
damage.
Phosphoric acid is also restricted as it can cause
damage.
Never use cleaning materials or appliances with an
abrasive effect, such as unsuitable cleaning powders,
sponge pads or micro fiber cloths.
Specifications
Sensor is self-adjusting (130 - 200 mm)
minimum required water pressure 0.05 MPa (Flowing)
maximum water pressure 1.0 MPa
Operation
Maintenance
B

Cleaning and care

-10-
AC 100 - 240 V
0 - 40°C
3 L/min
If the flow rate is low
1. Close the water shutoff valve.
2. Remove the lid and take out the filter, using the
special tool.
3. Scrub the filter gently with a tooth brush.
4. Open the water shutoff valve.
Please follow the cleaning material manufacturer's
instructions. In addition, pay attention to the following
points:
When using spray cleaners, spray first onto soft cloth or
sponge. Never spray directly onto the fittings, as drops
could enter openings and gaps then cause damage.
After cleaning rinse thoroughly with clean water to
remove any cleaner residue.
Components with damaged surfaces must be
exchanged, otherwise this could cause an injury.
Damage caused by improper treatment will not be
covered by our guarantee.
G3/8