Operating An Audio Device With This; Unit; Initializing Bluetooth Settings - Sony MEX-BT2900 Mode D'emploi

1 Start playback of the Bluetooth audio device at
a moderate volume.
2 Set your usual listening volume on the unit.
3 Press the select button.
4 Press the select button repeatedly until "BTA"
appears, and rotate the control dial to adjust
the input level ("+18dB" – "0dB" – "– 8dB").

Operating an audio device with this

unit

You can perform the following operations on this
unit if the audio device supports AVRCP (Audio
Video Remote Control Profile) of Bluetooth
technology. (The operation differs depending on
the audio device.)
To Press
(3) (REP)*
Repeat play
(4) (SHUF)*
Shuffle play
(1)/(2) (ALBUM –/+)
Skip albums
[press once for each album]
(6) (PAUSE)*
Play
(6) (PAUSE)*
Pause
Skip tracks SEEK –/+ (
once for each track]
Reverse/ SEEK –/+ (
Fast-forward desired point]
*1 Press repeatedly until the desired setting appears.
*2 Depending on the device, it may be necessary to
press twice.
Operations other than the above should be
performed on the audio device.
Notes
• Depending on the audio device, its information, such
as title, track number/time, playback status, etc.,
may not be displayed on this unit. The information is
displayed during Bluetooth Audio playback only.
• Even if the source is changed on this unit, playback
of the audio device does not stop.
Tip
You can connect a cellular phone that supports A2DP
(Advanced Audio Distribution Profile) as an audio
device and listen to music.
1
1
2 on this unit.
2 on this unit.
. / > ) [press
. / > ) [hold to

Initializing Bluetooth Settings

You can initialize all the Bluetooth-related
settings from this unit.
This setting appears when turned off.
1
Press and hold (SOURCE/OFF) for 1
second to turn off the power.
2
Press and hold the select button.
The menu list appears.
3
Rotate the control dial to select "BT
INIT," then press it.
The confirmation appears.
4
Rotate the control dial to select "INIT-
YES," then press it.
"INITIAL" flashes while initializing the
Bluetooth settings.
"COMPLETE" appears when initializing has
finished.
Note
When disposing of this unit, preset numbers should be
deleted with "BT INIT."
21