Usage - Working With The Machine; Processing Instructions; Shutting The Machine Off - Nilfisk Advance SD 400 Mode D'emploi

SD 400 / SD 430 / SD 500 / SDP 430
2 _4.2

Usage - working with the machine

Picture 4: Tilt the guide shaft (6) into the operating
position by actuating the shaft adjustment lever (3) and
engage. With handle in upright position an additional
safety lock prevents accidental switching-on! Connect
the mains connection lead (4) to the mains power
supply with the plug. The machine is continuously ope-
rated by releasing the safety device - press switch-on
safety device (1) towards the centre - and constant
depression of one or two of the operating buttons (2).
The mains connection lead (4) is to be routed so that it
lies behind you. Always work in the opposite direction to
the socket.
Picture 4
•
When slightly raising the handle the machine moves
to the right.
•
When slightly lowering the handle the machine
moves to the left.
Ensure that polishing is never carried out
in one position for a long period of time.
This may otherwise result in damage to
the floor covering.
16
2 _4.3

Processing instructions

The cleaning agent which is applied may
possibly lead to a risk of slipping!
For this reason, shows with non-slip soles
must be used when working!
Corresponding warning signs must be
erected!
2 _4.4

Shutting the machine off

Picture 4: Let on / off levers (2) off. Hold on to the
handle top (5) until the machine has come to a
complete standstill. On releasing the guide shaft (6), the
operating buttons (2) are automatically secured. Set (3)
to vertical position.
After operating the machine pull out the
mains plug (2, picture 1)!
Tip the machine backwards. Remove floor pad from
drive disc. Take brush / drive disc off the machine by
turning counterclockwise manually. Put the machine
back up. Wind mains cable (4) over handle top (5) and
mains cable coiling hook (7).
Do not allow
accessories for long periods of time (see
table 2).
2 _4 Operation
machine to rest on