Table Des Matières; Parts And Service; Nameplate; Uncrate The Machine - Nilfisk Advance ES4000 Mode D'emploi

A-2 / ENGLISH
TABLE OF CONTENTS
Introduction ..........................................................................................................A-2
Cautions and Warnings .......................................................................................A-3
Know Your Machine .................................................................................... A-4 - A-5
Control Panel .......................................................................................................A-6
Prepare the Machine for Use
Install the Batteries ..............................................................................................A-7
Filling the Solution Tank .......................................................................................A-8
Pre-Spraying the Carpet ......................................................................................A-8
Plan for Cleaning .................................................................................................A-8
Detergent System Preparation & Use ........................................................ A-8 - A-9
Operating the Machine
Operating the Machine-Sweep Mode ..................................................... A-10 - A-11
Operating the Machine-Extract Mode ..................................................... A-12 - A-13
Using Attachments .............................................................................................A-12
INTRODUCTION
This manual will help you get the most from your Advance Rider Extractor. Read it thoroughly before operating the machine.
Note: Bold numbers in parentheses indicate an item illustrated on pages 4-6.
This product is intended for commercial use only.

PARTS AND SERVICE

Repairs, when required, should be performed by your Authorized Advance Service Center, who employs factory trained service personnel, and maintains an inventory of Advance
original replacement parts and accessories.
Call the ADVANCE DEALER named below for repair parts or service. Please specify the Model and Serial Number when discussing your machine.
MODIFICATIONS
Modifi cations and additions to the cleaning machine which affect capacity and safe operation shall not be performed by the customer or user without prior written approval from Nilfi sk
Inc. Unapproved modifi cations will void the machine warranty and make the customer liable for any resulting accidents.
NAME PLATE
The Model Number and Serial Number of your machine are shown on the Nameplate on the machine. This information is needed when ordering repair parts for the machine.
Date of Manufacture "Date Code" is also marked on the Nameplate. For example, Date Code "A17" = January 2017.
Use the space below to note the Model Number and Serial Number of your machine for future reference.
MODEL No.
__________________________________________________________
SERIAL No.
__________________________________________________________

UNCRATE THE MACHINE

When the machine is delivered, carefully inspect the shipping packaging and the machine for damage. If damage is evident, save the shipping carton (if applicable) so that it can
be inspected. Contact the Advance Customer Service Department immediately to fi le a freight damage claim. Refer to the unpacking instruction sheet included with the machine to
remove the machine from the pallet.
WARNING!
The Products sold with this Manual contain or may contain chemicals that are known to certain governments (such as the State of California, as
identifi ed in its Proposition 65 Regulatory Warning Law) to cause cancer, birth defects or other reproductive harm. In certain locations (including
the State of California) purchasers of these Products that place them in service at an employment job site or a publicly accessible space are
required by regulation to make certain notices, warnings or disclosures regarding the chemicals that are or may be contained in the Products at
or about such work sites. It is the purchaser's responsibility to know the content of, and to comply with, any laws and regulations relating to the
use of these Products in such environments. The Manufacturer disclaims any responsibility to advise purchasers of any specifi c requirements that
may be applicable to the use of the Products in such environments.
A-2 - FORM NO. 56091013 - ES4000
page
After Use ............................................................................................................A-14
Maintenance Schedule ......................................................................................A-14
Vacuum Shoe Maintenance ...............................................................................A-14
Spray Nozzle Maintenance ................................................................................A-14
Lubricating the Machine ....................................................................................A-14
Electromagnetic Brake ......................................................................................A-14
Cleaning the Vacuum Motor Filters ...................................................................A-15
Power Brush Maintenance ................................................................................A-15
Removing the Front Brush .................................................................................A-15
Removing the Rear Brush .................................................................................A-15
Removing the Vacuum Shoes ...........................................................................A-16
Removing the Spray Nozzles ............................................................................A-16
Charging the Batteries .......................................................................................A-17
Check the Battery Electrolyte Level ...................................................................A-17
Troubleshooting .................................................................................................A-18
Technical Specifi cations ....................................................................................A-19
page
revised 1/18