Before The First Use; Ironing With Steam - Domo DO7054S Mode D'emploi

PARTS
1. Sole of iron
2. Spray opening
3. Water reservoir
4. Steam regulator + self-
cleaning
5. Spray button
6. Steam boost button
7. Cord
8. Indication light
9. Temperature button

BEFORE THE FIRST USE

· The iron must always be at "Min" if you put the plug in or take it out of the outlet.
· Never pull on the cord but on the plug itself.
· Remove the plastic protection from the sole of the iron (if present) and clean the sole of
the iron with a soft cloth.
· Remove the plastic protection from the sole of the iron (if present) and clean the sole of
the iron with a soft cloth.
· Some parts of the iron have been greased lightly, so the device may emit a slight odour and
some smoke with initial use. This is normal and will not happen after initial use.
· Keep the sole of the iron smooth and be careful for scratches. Do not slide with the sole of
the iron over metal surfaces, such as the edge of the ironing board, buttons or zippers.
· Before using for the first time, iron an old towel at the maximum temperature to remove
all residues of the manufacturing process.
USE
· Fill the water reservoir as indicated in "Filling the water reservoir".
· Put the plug of the device in the outlet, the indicator light will light up.
· Make sure that the steam regulator is set to the no steam
· Turn the temperature regulator to the desired position: see "Temperature selection". The
indicator light will turn off when the appliance has reached the selected temperature.

IRONING WITH STEAM

· Turn the temperature regulator to a temperature that includes steam
"cotton" and "linen".
· Make sure that the water reservoir is always at least ¼ full. If the water level is too low,
steam will not be produced.
30
DO7054S
INSTRUCTION MANUAL
6
5
4
3
2
1
Read instruction manual carefully before using the appliance
IMPORTANT SAFEGARDS
Before using the electrical appliance, the following basic precautions should always be
followed including the following:
1. Read all instructions and save it for future reference.
2. Before using check that the voltage of wall outlet corresponds to the one shown on the rating
plate.
3. Burns may occur from touching hot metal parts, hot water, or steam. Use caution when you
turn a steam iron upside down as there may be hot water in water tank.
4. If any part is damaged it must be replaced by the manufacturer or an authorized service
agent or a qualified technician in order to avoid a hazard.
5. Don't operate any appliance with a damaged cord or plug or after the appliance malfunctions,
or is dropped or damaged in any manner, Return the appliance to the nearest authorized service
facility for examination, repair or electrical or mechanical adjustment.
6.Do not let cord hang over edge of table or hot surface.
MODEL: ETA-67
position.
7
8
9
. This is for