Zanussi ZWQ 6100 Notice D'utilisation page 12

1
2
Untying
A B
C
D
B
2
1
Keep the transit bolts
for when you move
the appliance.
12
A
1 B
2
D
To install the appli-
ance at the same lev-
el as neighboring fur-
niture, cut these plas-
tic pieces.
Water supply
90 90 90
O O O
In case of necessity
move the inlet hose in
the direction shown
on picture. To make
this loose the inlet
hose ring nut and po-
sition the inlet hose
downwards as drawn
on picture. Tighten
the ring nut back and
make sure there are
no leaks.
Drainage
Fit the U-piece on the
drainage hose. Place
everything in a drainage
point (or in a sink) at a
height of between 70
and 100 cm. Ensure it
is positioned securely.
Air must be able to en-
ter the end of the hose,
to avoid any risk of siphoning.
The drain hose must never be stretched. If it is
too short, contact an engineer.
Electrical connection
This washing machine must only be connected
in single-phased 230 V. Check the fuse size:
10 A for 230 V. The appliance must not be
connected with an extension lead or multi-plug
adaptor. Ensure that the plug is earthed and
that it is in accordance with current regulations.
Positioning
Position the appliance on a flat and hard sur-
face in a ventilated location. Ensure the appli-
ance does not come into contact with the wall
or other furniture. Accurate levelling avoids vi-
Open the water inlet
tap. Check there are
no leaks. The water
inlet hose can not be
extended. If it is too
short, please contact
the after-sales serv-
ice.
min
max
70 cm
100 cm
www.zanussi.com